tomi

Determine the number of moles of a) N atoms in 42.5g of Mg(NO3)2 b) N atoms in a sample of C7H5(NO2)3 that has the same number of O atoms as 12.6g C6H12O6

17 years ago

To determine the approximate mass of a small spherical shot of copper, the following experiment is performed. When 140 pieces of the shot are counted out and added to 8.6ml of water in a graduated cylinder, the total volume becomes 8.8ml . The density of...

17 years ago

Determine the number of moles of N atoms in a sample of C7H5(NO2)3 that has the same number of O atoms as 12.6g C6H12O6

17 years ago

Determine the number of moles of a) N atoms in a sample of C7H5(NO2)3 that has the same number of O atoms as 12.6g C6H12O6 Someone posted a way to answer this question but i still don't understand

17 years ago

A gaseous mixture of O2 and N2 contains 32.8% nitrogen by mass How do i figure out wat the mass is?

17 years ago

A 2.34L container of H2(g)at 752mmHg and 24 degrees is connected to a 3.17L container of He(g) at 717mmHg and 24 degrees. After mixing, what is the total gas pressure, in millimeters of mercury, with the temperature remaining at 24 degrees?

17 years ago

Helium-oxygen mixtures are used by divers to avoid the bends and are used in medicine to treat some respiratory ailments. What percent (by moles)of He(g) is present in a helium-oxygen mixture having a density of 0.538g/L at 25celsius and 721mmHg ?

17 years ago

The combustion of hydrogen–oxygen mixtures is used to produce very high temperatures (approximately 2500 °C) needed for certain types of welding operations. Consider the reaction to be H2(g) + 1/2O2(g) --> H20(l) Standard enthalpy is -241.8kj What is the...

17 years ago

Calculate the standard enthalpy change for the reaction 2A+B->2C+D Use the following data: Substance A=-257kj/mol B=-413kj/mol C=189kj/mol D=-475kj/mol For the reaction given , how much heat is absorbed when 3.00mol of A react?

17 years ago

The complete combustion of butane, (g) is represented by the equation C4H10+ 13/2O2->4CO2+5H2O standard enthalpy is -2877kj How much heat, in kilojoules, is evolved in the complete combustion of 12.8ml at 23.8degrees celsius and 744mmhg ?

17 years ago

A calorimeter contains 16.0ml of water at 15.0degrees celsius. When 1.60g of X(a substance with a molar mass of 46.0g/mol) is added, it dissolves via the reaction X(s)+H20(l)->X(aq) and the temperature of the solution increases to 25.0degrees celsius. Cal...

17 years ago

How much energy, in joules, must be absorbed to convert to Na all the atoms present in 1.00mg of gaseous Na? The first ionization energy of Na is 495.8kj/mol .

16 years ago

What electron transition in a hydrogen atom, starting from the orbit 10, will produce infrared light of wavelength 3040 ?

16 years ago

a mixture is prepared using equal masses of two volatile liquid benzene, C6H6 and ethanol C2H5OH. what is the mole fraction of benzene in this mixture?

16 years ago

a compound containing only boron, nitrogen and hydrogen was found to be 40.3% B, 52.2%N, and 7.5% H by mass. If 3.301g of this compound is dissolved in 50.00g of benzene, the solution produced freezes at 1.30 degrees celsius. If Kf(freezing point depressi...

16 years ago

Draw the electron-dot structure for CHClO.

16 years ago

The average bond enthalpy for a C=C double bond is 614kj/mol and that of a C-C single bond is 348kj/mol . Estimate the energy needed to break the pi bond in 2-butene. CH3 CH3 CH3 H \ / \ / C=C ------> C=C / \ / \ H H H CH3 Cis-2-butene Trans-2-butene

16 years ago

Use bond energies to estimate the enthalpy change for the following reaction C2H2 + H2-> C2H4 i figured the bonds broken are: 1 C triple bond C 1(812kj/mol) 2 C-H 2(414kj/mol) 1 H-H 1(435kj/mol) Bonds formed 1 C=C 1(590kj/mol) 4 C-H 4(435kj/mol) Is this r...

16 years ago

What is the longest wavelength of light that will provide photons of sufficient energy to break the pi bond and cause the isomerization? Energy required to break pi bond is 4.42*10^-19. wavelenght=c/f but how do i figure out what f is?

16 years ago

The normal boiling point of water is 100.00 degrees celsius and the enthalpy of vaporization at this temperature is 40.657kj/mol. What would be the boiling point of water if it were based on a pressure of 1 bar instead of the standard atm?

16 years ago

What is the boiling point of water at an elevation of 1.55×10^4 ft ? The atmospheric pressure at sea level is 760mmHg . This pressure decreases by 19.8mmHg for every 1000-ft increase in elevation. The boiling point of water decreases 0.05 degrees celsius...

16 years ago

i have to catogerize the list based on which is ionic, polar covalent, and nonpolar covalent 1.SI 2.HBr 3.HP 4.SO 5.BeF 6.BeCl 7.ScO

16 years ago

"context affects content" what does this mean

16 years ago

A student placed 12.5 of glucose () in a 100.- volumetric flask, added enough water to dissolve the glucose by swirling, then carefully added additional water until the calibration mark on the neck of the flask was reached. The flask was then shaken until...

16 years ago

The enzyme Y catalyzes the elementary reaction AB-->A + B An enzyme concentration of 1.0M Y can convert a maximum of 0.5M AB to the products A and B per second. What will happen when each of the following is added to a solution that contains 1.0M Y and 0....

16 years ago

A solution is prepared by dissolving 10.00g of a monobasic salt in a total volume of 1.00litres. Th pH of this solution was measured at 13.07 and a conductivity experiment determined that this salt was completely ionized in solution. What is the molecular...

16 years ago

The pH of saturated Sr(OH)2 is found to be 13.12. A 15.0ml sample of saturated Sr(OH)2 is diluted to 250.0ml in a volumetric flask. A 15.0ml sample of the diluted Sr(OH)2 is transferred to a beaker, and some water is added. The resulting solution requires...

16 years ago

The following equation describes the oxidation of an acidified solution of sodium oxalate (Na2C2O4) by potassium permanganate(KMnO4) 5C2O4 + 2MnO4 + 16H2SO4 --> 10CO2 + 2Mn + 16HSO4 + 8H20 What volume of 0.127M sodium oxalate in sulphuric acid will react...

16 years ago

Calculate [H3O] in the following solutions. a)4.0×10−2M HCl and 8.0×10−2M HOCl b)0.105M NaNO2 and 5.00×10−2M HNO2 c)5.15x10-2M HCl and 7.62x10-2M NaC2H3O2

16 years ago

Calculate [H3O] in the following solutions. 5.15x10-2M HCl and 7.62x10-2M NaC2H3O2 Responses HCl + NaC2H3O2. It appears there is an excess of H^+ which will react with NaC2H3O2 to form HC2H3O2. That gives you a buffer of C2H3O2 and HC2H3O2 and you use the...

16 years ago

A sample of 7.80L of NH3(ammonia) gas at 22 degrees Celsius and 735torr is bubbled into a 0.350L solution of 0.400M HCl (hydrochloric acid). The Kb value for NH3 is 1.8x10-5. Assuming all the NH3 dissolves and that the volume of the solution remains at 0....

16 years ago

A 75.0mL sample of 1.56×10−2M Na2SO4(aq) is added to 75.0mL of 1.22×10−2M of Ca(NO3)2(aq). What percentage of the Ca+ remains unprecipitated?

16 years ago

If you were to use an aquatic plant for your starting material, what would you expected to see in terms of pigments and absorption spectra, in comparison to results from a spinach? Explain.

16 years ago

1.Pippete 20ml of 0.1M acetic acid and 20ml of 0.1M NaOH into a 100ml beaker (Remember that the final volume of this solution is the sum of the volumes of the acetic acid and NaOH solutions that have been mixed) 2. Pippete 20ml of 0.1 acetic acid into ano...

16 years ago

i don't get what u mean

17 years ago

still confused

17 years ago

wat do u mean by change density to stp

17 years ago

NVM FIGURED IT OUT

16 years ago

thx

16 years ago

nvm i figured it out

16 years ago

For which figure type are the line of this gown most flattering?.A tall.B. short or plump.C.Thin. D. Average

13 years ago