Ask a New Question

Question

A 3.0cm diameter crankshaft that is rotating at 2500 rpm comesto a halt in 1.5 s.
a- what is the tangential acceleration of a ponit on thesurface?
b-how many revolutions does the crankshaft make as itstops?

For this question, what are the applicable concepts and/or laws and assumptions and/or simplifications?
9 years ago

Answers

Chanz
a)
α = ω/t
make sure you do the conversions
b) θ = ωo t + ½ α t2
then unconvert from rads to revs
9 years ago

Related Questions

If a bicycle has a crankshaft of 40 teeth, and there are three rear sprockets attached to the rear w... What is the diameter of the following circle: (x + 4)2 + (y – 9)2 = 18 what is the diameter if a 1.00m tungsten wire whose resistence is 0.22 ohms? what is the diameter of a 1.00m lenght of tungsten what is the diameter of a 1.00 m length of tungsten wire whose resistance is 0.22 ohms? The crankshaft of an engine increases its spin from 1,200 rpm to 1,500 rpm in 0.50 s. What is its an... The outside diameter of a pipe is 5 cm. The inside diameter is 4 cm. The pipe is 4 meters long.... 1.What is the diameter of a sphere that has a volume of 3052.08 m^3? My answer is: 9m 2.What is... The crankshaft in your car engine is turning at a frequency of 3000 rpm. What is the shafts angular... what is the diameter of the cone ? 11mm and 5mm
Ask a New Question
Archives Contact Us Privacy Policy Terms of Use