What’s required to use the Service Port on a WLC? (Choose three.)

Question

Group of answer choices

The switchport must be configured to be a trunk.

The switchport must be configured to an access port.

The service port interface must be connected to a switch.

You must add static routes to the WLC.

Answer 1

To use the Service Port on a Wireless LAN Controller (WLC), the following are typically required:

1. The service port interface must be connected to a switch.
2. You must add static routes to the WLC.
3. The switchport must be configured to be a trunk. (This one is typically necessary if you want to allow multiple VLANs over the connection).

So the correct choices are:

• The service port interface must be connected to a switch.
• You must add static routes to the WLC.
• The switchport must be configured to be a trunk.

However, please note that specifics might vary based on the exact configuration and deployment scenario, so it's always good to refer to the official documentation for your particular WLC model.