Question

17.Using the given output, what type of interface is shown?
[output cut]
Hardware is MV96340 Ethernet, address is 001a.2f55.c9e8 (bia 001a.2f55.c9e8) Internet address is
192.168.1.33/27
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, reliability 255/255, txload 1/255, rxload 1/255
a. 10 Mb
b. 100 Mb
c. 1000 Mb
d. 1000 MB
18. Which of the following commands will configure all the default V TY ports on
a switch?
a. Switch# line vty 0 4
b. Switch(config)# line vty 0 4
c. Switch(config-if)# line console 0
d. Switch(config)# line vty all
19. Which of the following commands sets the privileged mode password to Cisco
and encrypts the password?
a. enable secret password Cisco
b. enable secret cisco
c. enable secret Cisco
d. enable password Cisco
20. If you wanted administrators to see a message when logging into the switch,
which command would you use?
a. A. message banner motd
b. banner message motd
c. banner motd
d. message motd
21. Which of the following prompts indicates that the switch is currently in
privileged mode?
a. Switch(config)#
b. Switch>
c. Switch#
d. Switch(config-if)
22. What command do you type to save the configuration stored in RAM to NVRAM?
a. Switch(config)# copy current to starting
b. Switch# copy starting to running
c. Switch(config)# copy running-config startup-config
d. Switch# copy run start

Answer 1

17. b — 100 Mb (BW 100000 Kbit indicates a 100 Mbps interface)
18. b — Switch(config)# line vty 0 4
19. c — enable secret Cisco
20. c — banner motd
21. c — Switch# (privileged exec prompt ends with #)
22. d — Switch# copy run start