Question

Which command displays the status of all HSRP groups on a Cisco router or layer 3 switch?
Group of answer choices

show standby

show ip hsrp

show hsrp

show standby hsrp
GPT-4o mini
The correct command to display the status of all HSRP (Hot Standby Router Protocol) groups on a Cisco router or layer 3 switch is:

**show standby**

This command provides detailed information about the HSRP groups configured on the device, including the active and standby routers' IP addresses and the group status.

Related Questions

Which of the following would be a good starting point for troubleshooting if your router is not tran... Question 232 pts In OSPF, what is a router called that connects different areas together? Group o... Which command configures an interface to enable HSRP with the virtual router IP address 10.1.1.10?... Two routers are part of an HSRP standby group and there’s no priority configured on the routers for...