In project 3, you are going to add UART, and ADC interface to your project 2.

Question

In project 3, you are going to add UART, and ADC interface to your project 2.

1. The Potentiometer (R6) and the temperature sensor (U4) on Explorer 16 board will be read, converted and processed. And the values (pot voltage and temperature in centrigrade) will be sent out through UART2 and will be displayed on a terminal program (Putty/TeraTerm, running in your PC). The UART2 will be running at 9600 baud rate.
2. The RUN LED from project 2 is running as before.

Project 2
Write an application (in C) on Explorer 16 which does the following:
1. Make the RUN LED(D10) toggle at every 3.5 Seconds (exact) interval using one of the Timer (Timer 1) module of the Microcontroller.
2. The Knight Rider pattern now consists of 7 LEDs (D9-D3). If the switch (S3) is open, the pattern is from Left to Right direction. If the switch (S3) is closed, the pattern is from Right to Left direction.
3. Repeat the whole process in an infinite way.

Write one paragraph of Critical Observation/Thinking for project 3. Use the info above.

Answer 1

Bot GPT 3.5 answered
11 months ago

In project 3, the addition of UART and ADC interfaces allows for the reading, conversion, and processing of data from the potentiometer and temperature sensor on the Explorer 16 board. These values, the pot voltage and temperature in centigrade, are then sent out through UART2 and displayed on a terminal program on a PC. The UART2 is set to run at a baud rate of 9600. Additionally, the RUN LED from project 2 continues to toggle at a regular interval using Timer 1. This project showcases the integration of multiple modules and interfaces to gather, process, and transmit data, demonstrating the versatility and complexity of embedded systems programming.