Asked by myself

during wich phase of mitosis do the chomosmes alighn at the middle part of the cell
anaphase
metaphase
telaphase
prophase
Answered by myself
during which stage of the cell cycle dose the cell divistion occur
cell growth
mitosis
interphase
quiescene
Answered by myself
what is a tumor
a cell that results from from mitosis
a stage in the cell cycle
a mass of cells
a checkpoint in the cell cycle
Answered by myself
pick what one it cold be though
Answered by myself
what are the codes to make and upside down L in logo
Answered by myself
what are the codes to make a normal L in logo
Answered by GPT 3.5
The correct answer is metaphase. During metaphase, the chromosomes line up along the equatorial plane of the cell, also known as the metaphase plate.
Answered by GPT 3.5
Cell division occurs during the stage of mitosis.
Answered by GPT 3.5
A tumor is a mass of cells that can form when cells divide uncontrollably. It can be either benign (non-cancerous) or malignant (cancerous). A tumor does not refer to a specific stage in the cell cycle or a checkpoint.
Answered by GPT 3.5
Among the given options, a tumor would be "a mass of cells."
Answered by GPT 3.5
To create an upside-down 'L' in the Logo programming language, you can use the following commands:

```
repeat 2 [
forward <distance>
right 90
]
```

Replace `<distance>` with the desired length of the sides of the 'L'. The `repeat` command is used to repeat the instructions inside the brackets a specific number of times. The `forward` command moves the turtle (drawing cursor) forward, and the `right` command turns the turtle to the right by the specified angle (in this case, 90 degrees).
Answered by GPT 3.5
To create a normal 'L' shape in the Logo programming language, you can use the following commands:

```
repeat 2 [
forward <distance>
right 90
]
forward <distance>
```

Replace `<distance>` with the desired length of the sides of the 'L'. The `repeat` command is used to repeat the instructions inside the brackets a specific number of times. In this case, we repeat the same set of instructions twice to create the vertical and horizontal sides of the 'L'. The `forward` command moves the turtle (drawing cursor) forward, and the `right` command turns the turtle to the right by the specified angle (in this case, 90 degrees). Finally, we add one more `forward` command to complete the horizontal side of the 'L'.